It takes a few minutes for my tankless water heater to warm up, so we end up wasting a lot of water in our shower. Is there a way to avoid this? A friend mentioned a “comfort valve” or something? What is it and how does it work? Or is there another solution? Thx!

  • @SheeEttin@lemmy.world
    link
    fedilink
    English
    252 years ago

    With a tankless heater, there’s nothing to warm up. Hot water is basically instant when it comes out.

    How far is your shower from the heater? Usually, long times to first heat are because you have to go through all the cold water sitting in the line before the hot water reaches you.

    • @crozilla@lemmy.worldOP
      link
      fedilink
      72 years ago

      Yes, that. That’s a better explanation of the problem. Thanks. The shower is way on the other side of the house and up a floor.

      • @Bell@lemmy.world
        link
        fedilink
        72 years ago

        If wiring and plumbing allow, install another tankless heater closer to the shower. I just put one into my one bedroom apartment and it was reasonably simple and small.

        • @crozilla@lemmy.worldOP
          link
          fedilink
          32 years ago

          Unfortunately, the shower has no exposed plumbing and the gas line is back near the ground floor heater.

          • @SheeEttin@lemmy.world
            link
            fedilink
            English
            12 years ago

            You’ll have to relocate the heater closer to the shower. You can have someone run the gas line to the new location. That’s about all you can do.

            You could insulate the hot water pipe, but that will only help when the water in the pipe is already hot, like if someone showered earlier. It only extends the time the water already in the pipe remains hot.

      • @OhmsLawn@lemmy.world
        link
        fedilink
        12 years ago

        They make instant recirculation pumps that cycle the water through the tankless in a loop and stop when the hot water gets back to the pump. We have one. If you don’t already have the return pipes for it, you’d need some additional plumbing work. (Either way, it should be professionally installed).

        It’s the same system you’d have for a tank, but it can’t run all the time, or it burns up the heater. You have to trigger it. They make flow switches, but mine (new construction) was cheesed. I just set up a zigbee switch with a 1 minute timer to trigger the pump.